Custom Shield

Custom Shield

As an excuse to use Fritzing Fab service, may design and order a custom shield for all of my buttons and LEDs. Not really a shield since it won't draw power; rather, it's more of a pin aggregator that would go on the Mega board not covered by the NXT motor shield.

Design may include

  • 8 LED row to display sensor array status
  • 4 corner LEDs for edge detection sensor status
  • 4 LEDs for binary display of modes
  • 4 pushbuttons (2 planned for use plus 2 extra?)
  • LCD display (room?)
Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License